Sony STR-DG500 - Manual (Page 71)

71 GB
F:\Sony SEM
HA\Revision5_DG500\JC060283_2662258132DG500_GB\2662258132\GB05AMP_STR-DG500-
CEL.fm masterpage: Right
STR-DG500
2-662-258-13 (2)
Ad
diti
on
al
I
n
fo
rmatio
n
PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 25). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA
Stereo Power Output
1)
, Reference Power
Output
1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
100 W + 100 W, 110 W/ch
8 ohms 1 kHz, THD 0.7%
110 W + 110 W, 120 W/ch
8 ohms 1 kHz, THD 10%
125 W + 125 W, 150 W/ch
Models of area code CEL, CEK, E2, TW, AU
Stereo Power Output
1)
, Reference Power
Output
1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
85 W + 85 W, 110 W/ch
8 ohms 1 kHz, THD 0.7%
100 W + 100 W, 120 W/ch
8 ohms 1 kHz, THD 10%
125 W + 125 W, 150 W/ch
Models of area code SP
Stereo Power Output
1)
, Reference Power
Output
1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
70 W + 70 W, 90 W/ch
8 ohms 1 kHz, THD 0.7%
80 W + 80 W, 100 W/ch
8 ohms 1 kHz, THD 10%
100 W + 100 W, 125 W/ch
To clear See
All memorized settings page 25
Customized sound fields page 53
continued
GB01COV_STR-DG500-CEL.book Page 71 Thursday, March 16, 2006 12:10 PM