SECO-LARM USA Enforcer DP-121Q - Manual (Page 5)

ENFORCER VIDEO DOOR PHONE
SECO-LARM U.S.A., Inc. 5
Figure 2 – Back of
Primary Monitor Detail
Camera 2 and Monitor 2 sockets
are used only with optional
additional monitor and camera.
Installing a Second Monitor:
6. Plug the AC Power Adapter’s cable into the
“Power” socket on the back of the monitor.
7. Run the wires going to the camera under the
plastic hooks on the back of the monitor so
that any tension on them will not be directly
transferred to the plugs or sockets.
8. Plug the AC power adapter into a 120VAC
socket.
9. Test the monitor and camera unit by pressing
the camera button. The image in front of the
camera should be displayed clearly.
Camera
1
Not
Used
Monitor
2
Camera
2
Power
Figure 3 – Back of
Secondary Monitor Detail
Main
Monitor
Not
Used
Power
10. If using a secondary monitor, follow steps
1-4 on page 4.
11. Plug the brown 4-pin plastic connector from
the camera into the “Main Monitor” socket
(see Figure 3).
NOTE: There will be an unused socket on
the back of the secondary monitor.
12. Follow steps 6-9 above to complete the
installation