Sony CPD-L133 - Manual (Page 32)

12
Customizing Your Monitor
Displaying the Picture at the
Actual Resolution
The monitor is set at the factory to display the picture on the
screen in full, irrespective of the picture’s resolution. You
can also view the picture at its actual resolution.
Once the zoom is set, it will be stored in memory for the
current input signal.
1
Press the MENU button.
The MENU OSD appears.
2
Press the ø / ‡ buttons to select ZOOM, and press the
MENU button again.
The ZOOM OSD appears.
3 Press the ‡ button to select REAL MODE, and press
the MENU button again.
The MENU OSD appears.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To display the picture on the screen in full
Press the ø button in step 3 to select FULL MODE.
Adjusting the Picture Position
If the picture is not in the center of the screen, press the
AUTO button. If this operation does not work, adjust the
centering as follows.
Once the centering is adjusted, it will be stored in memory
for the current input signal.
1
Load the Utility Disk (page 10).
2 Press the MENU button.
The MENU OSD appears.
3 Press the ø / ‡ buttons to select CENTER, and press
the MENU button again.
The CENTER OSD appears.
4
For horizontal adjustment, select H using the ø / ‡
buttons and adjust the position using the +/–
buttons.
+ . . . to move the picture right
– . . . to move the picture left
For vertical adjustment, select V using the ø / ‡
buttons and adjust the position using the +/–
buttons.
+ . . . to move the picture up
– . . . to move the picture down
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To turn off the test pattern, click [END] on the screen.
MENU
EXIT
PHASE
PITCH
CENTER
ZOOM
COLOR
MENU OK
MENU
MENU
CENTER
H
V
26
CENTER
H
V
26
CENTER
H
V
26
MENU
EXIT
PHASE
PITCH
CENTER
ZOOM
COLOR
LANGUAGE
OPTION
MENU OK
MENU
MENU
ZOOM
FULL MODE
REAL MODE