Sony 3-287-077-14(2) - Manual (Page 37)

37 GB
Oth
e
rs
To change the AM tuning interval
(except for European and Russian
models)
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas). You
cannot change the AM tuning interval in
Power Saving Mode.
Use the buttons on the unit for this
operation.
1
Select the AM band, and then turn
off the system.
2
While holding down ENTER, press
"/1.
The system turns on automatically and
“AM 9K STEP” or “AM 10K STEP”
appears.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
To reset the system to factory
settings
If the system still does not operate
properly, reset the system to factory
settings. You cannot reset the system to
factory settings in Power Saving Mode.
Use the buttons on the unit for this
operation.
1
Disconnect and reconnect the
power cord, and then turn on the
system.
2
Press x, ENTER, and "/1 at the
same time.
“COLD RESET” appears in the
display.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are reset to factory setting.
Messages
CD/MP3 player, Tuner, Tape
LOCKED:
The disc tray does not open.
Contact your nearest Sony dealer.
NO DISC:
There is no disc on the disc
tray.
NO STEP:
All of the programmed steps
have been erased.
NOT IN USE:
You pressed an invalid
button.
OFF TIME NG: The Play Timer or
Recording Timer start and stop times
are set to the same time.
OVER:
You have reached the end of the
disc while pressing M during
playback or pause.
PUSH SELECT:
You tried to set the
clock or timer during timer operation.
PUSH STOP: Stop playback, then select
the play mode.
READING:
The system is reading
information of the disc. Some buttons
are not available.
SET CLOCK:
You pressed CLOCK/
TIMER SELECT (RM-AMU006)
before the clock is set.
SET TIMER: You pressed CLOCK/
TIMER SELECT (RM-AMU006)
before the Play Timer or Recording
Timer is set.
STEP FULL: You tried to program more
than 25 steps.
USB device
DATA ERROR: You tried to play a file
that is not playable.
DEVICE ERROR:
The USB device
could not be recognized or an unknown
device is connected (page 34).
Continued
l