Star Micronics ATAR LC-500 - Manual (Page 30)

– 26 –
ENGLISH
Panel lock mode
When the printer is in the panel lock mode, the mode settings you make
on the control panel are used even if your software tries to override the
mode. Use the following procedure to enter the panel lock mode.
1. While holding down the SET/PARK/EJECT button, press the LINE
FEED button. A short buzzer sounds once.
To exit from the panel lock mode, press the LINE FEED button while
holding down the SET/PARK/EJECT button. A short buzzer sounds
twice.
Panel macro
The settings you make on the front panel are cleared when the printer is
turned OFF. To save the current control panel settings so that they are
used the next time the printer is turned ON, use the following procedure.
1. While holding down the SET/PARK/EJECT button, press the ON
LINE button. Keep both buttons held down until the printer beeps
twice.
This procedure saves the following settings.
Print mode settings
Panel lock
To clear the panel macro, hold down SET/PARK/EJECT and ON LINE
until the printer beeps 3 times. If EDS2A-5 is OFF, this panel macro
function is ignored (see chapter 4).