Installing daughter boards, E1/pri, t1 board – Samsung SMG-3200 User Manual
Page 46
3-13
y To use the TYPE II-Standard signaling,
☞
Close
pin A and O.
E1/PRI, T1 Board
There are S1 and S2 switches and JP1~JP5 jumpers on the E1/PRI, T1 board. All of these switches
and jumpers are to select the kind of station line to be connected to the E1/PRI, T1 board. Prior to
the installation of the E1/PRI, T1 board onto the MGCB board, set switches and jumpers
according to following directions.
y To connect T1
☞
Close pin #1-2 of all jumpers.
☞
Set S1 switch to ON, and set S2 switch to OFF.
y To connect E1
☞
Close pin #2-3 of all jumpers.
☞
Set both S1 and S2 switches to ON.
y To connect E1 type PRI
☞
Close pin #2-3 of all jumpers.
☞
Set S1 switch to OFF, and set S2 switch to ON.
Installing Daughter Boards
Daughter board is installed according to user’s need and system construction.
The following boards require daughter board installation prior to board installation.
☞ MGCB Board
☞ VOIP Board
Other boards can be installed in a slot without installation of a daughter board.
This section provides daughter board installation procedures for each type of board.