Sony HTP-2000 - Manual (Page 12)

masterpage:Left
lename[E:\SEM_Janet\Revision_HTP-
200\J9040000_2103636121HTP1200CEL\2103636121\GB03CON_HTP-1200-CEL.fm]
12 GB
model name1[HTP-2000]
model name2[HTP-1200]
[2-103-636-12(1)]
Tips
• Since the sub woofer does not emit highly directional
signals, you can place it wherever you want.
• (Except for the front speaker of HTP-2000) For
greater flexibility in the positioning of the speakers,
use the optional WS-FV11 or WS-FV10D floor stand
(available only in certain countries).
Attaching foot pads
(Except for the front speaker of HTP-2000)
To prevent speaker vibration or movement,
attach the supplied foot pads to the speaker as
shown in the illustration below.
Note
Be sure to attach the supplied foot pads to the sub
woofer as well.
To change the speaker cord
If you want to change the speaker cord, you can
detach the supplied speaker cord from the
connector.
1
Press the connector onto a flat surface.
Make sure that the catcher is facing the flat
surface.
2
Pull the speaker cord from the
connector.
3
Twist the stripped ends of the speaker
cord you want about 10 mm and insert
the speaker cord into the connector.
Make sure that the speaker cord is inserted
according to its polarity : + to + and – to –.
Otherwise the sound will be distorted and
will lack bass.
4
Remove the connector from the flat
surface.
Note
To avoid the speaker cord from coming off the speaker
connector
– do not use a smaller-size speaker cord. We
recommend that you use the AWG#18 to AWG#24
speaker cords.
– use the same speaker cord size for all the speaker
connectors.
– twist the stripped ends of the speaker cords.
– insert the speaker cord completely into the speaker
connector.
catcher
+
–
(+)
(–)
GB01COV_HTP-1200-CEL.book Page 12 Thursday, September 23, 2004 6:22 PM