Sima Products Sima SUR-47 - Manual (Page 14)

Getting Started SUR-47 User’s Manual
10
Re-Labeling Devices
Follow these instructions to edit a device label.
1. Press or to select RELABEL .
2. Press .
3.
Press the device key you want to
relabel (for example TV).
4. Edit the device label:
• Press or to scroll through
the characters (from A-Z, 0-9,
and the space key).
Note: Press and hold or to
quickly scroll through the
characters.
• Press or to move to the
previous or next character.
When selected, the character
blinks.
• Press to confirm the entry.
5. Press Exit to exit to the device
menu.
Setting the RF Address
Each device button (TV, VCR, DVD etc.) can be set to operate on either IR or RF frequencies. When transmitting an IR signal
the SUR-47 will operate the selected device by directly sending IR signals to the device. To operate in this mode, you must
point the SUR-47 at the desired device.
To operate in the RF mode, the SUR-47 transmits an RF frequency signal to the SUR-BU base unit, which sends an IR signal to
the desired device. Both the device and the base unit must be set to the same RF address to operate properly. To set the
RF address:
1. Press or to select ADDR
2. Press OK
3. Select either IR to operate in the IR mode or an RF address (0-9) for the base unit and device
4. If an RF address is selected, set the base unit to the same RF address by adjusting the ADDRESS wheel on
the rear panel as needed.