Appendix 2: status specifications, Enq command status, Eot command status – Star Micronics Line Thermal Printer User Manual
Page 147
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
5-6
5.2. Appendix 2: Status Specifications
5.2.1.
ENQ Command Status
This status is the one the printer transmits using the ENQ command.
Bit Contents
Status
Model
Compatability
“0”
“1”
TSP800 TSP700 TSP600 TUP900 TSP1000
TSP828L TSP700II
TSP650
7 Conversion
SW
OPEN CLOSE OK OK OK No NO NO OK OK
6 Overrun
Error
No
Yes
OK OK OK OK OK OK OK OK
5 Reception
Buffer
Empty Has
Data Empty OK OK OK OK OK OK OK OK
4
Fixed
at
”0”
-
- - - - - - - -
3 Paper
end
Paper No
Paper OK OK OK OK OK OK OK OK
2 Other
Errors
No
Yes
OK OK OK OK OK OK OK OK
1 Framing
Error
No
Yes
OK OK OK OK OK OK OK OK
0 Parity
Error
No
Yes
OK OK OK OK OK OK OK OK
• Overrun errors/Framing errors/Parity errors
These errors occur when using a serial I/F.
These errors are after holding the error and using this command to inquire the status and the error status is sent.
• Other Errors
Indicates non-recoverable errors and cover open errors.
5.2.2.
EOT Command Status
This status is the one the printer transmits using the EOT command.
Bit Contents
Status
Model
Compatability
“0”
“1”
TSP800 TSP700 TSP600 TUP900 TSP1000
TSP828L TSP700II
TSP650
7 Compulsion
SW
OPEN CLOSE
- OK OK OK - - - OK OK
6
Presenter Paper Jam Error
No
Yes
No
No
No
OK
No
NO
NO
NO
5
Paper Near-end (Outer Side)
Paper
No
Paper No No No No No NO NO NO
4
Fixed
at
“1”
- - - - - - - - -
3 Paper
end
Paper No
Paper OK OK OK OK OK OK OK OK
2
Paper Near-end (Inner Side)
Paper
No Paper
OK
OK
OK
OK
OK
NO
OK
OK
1
BINDING MEDIA Error
No
Yes
No
No
No
OK
OK
OK
OK
NO
0
Fixed
at
“0”
- - - - - - - - -
• BM Error
On models that use a common PE and BM sensor, if a continuous error is detected beyond a determined amount, it
indicates not a black mark error, but a paper out error.