Sony KL-W9000 - Manual (Page 30)

– 30 –
KL-W7000/W9000
RM-Y980
Adjustment Items and Procedure Tools and Test Points Adjustment Places Illustration Waveforms and Values
Signals
* L5002
* L5004
* 13.67
±
0.10MHz
*
* 10.22
±
0.05MHz
*
* NTSC signal
* Frequency counter
* Double speed NTSC
* Oscilloscope
* NTSC signal
* Frequency counter
* Double speed NTSC
* Oscilloscope
C Board Adjustment
1. PLL fo adjustment
1)
WIDE mode
1. Select WIDE mode.
2. Open the CN5202 pin 1, H.SYNC input.
3. Connect *IC5004 pin 2 to the GND (*TP5009) via 100
Ω
resis-
tance.
4. Connect *frequency counter to the pin 1 of *IC5004.
5. Adjust *L5002 so as to satisfy the *specified value.
6. Input H.SYNC for NT double speed, and confirm the wave-
form at the *TP with *oscilloscope.
2) NORMAL mode
1. Select NORMAL mode.
2. Open the CN5202 pin 1, H.SYNC input.
3. Connect *IC5004 pin 2 to the GND (*TP5009) via 100
Ω
resis-
tance.
4. Connect *frequency counter to the pin 1 of *IC5004.
5. Adjust *L5004 so as to satisfy the *specified value.
6. Input H.SYNC for NT double speed
7. Confirm the waveform at the *TP5004 with *oscilloscope.
* IC5004 pin 2
* TP5009 Jig land
* IC5004
* TP5007 (RPD2)
* IC5004 pin 2
* IC5009
* IC5004 pin 1
* TP5007 (RPD1)




31.78 µ s
2.39 ± 0.1 µ s
5.0Vp-p
Use TP5009 as
reference GND.
Use TP5009 as
reference GND.




2.3
±
0.3 V