ScyTek Electronics 3000Plus Series - Manual (Page 23)

18. Start in Valet Mode.* Selects whether or not the vehicle can remote start while in the valet mode.
*Requires the optional ScyNet Network Remote Car Start Module.
19. Remote Start Program.* This dual program branch sets the engine mode for Gas or Diesel, and
learns the vehicle’s RPM threshold.
Learn RPM. When programming Branch 19, first set the engine type (default is gas), see below. After
engine type is set, start the engine, re-enter Branch 19 and press Button 1 to learn the vehicle’s tach
signal.
Gas Engine. Sets the engine type for Gasoline.
Diesel Engine. Sets the engine type for Diesel.
See the remote start’s manual for more details.
*Requires the optional ScyNet Network Remote Car Start Module.
20. Automatic Start Mode.* Allows selection of automatic engine starting when the remote start module
is connected.
Auto Low Temperature Starting. When the ambient temperature drops below a preset point, the engine
will automatically start and run for the preset time to avoid engine freezing.
Auto Low Voltage Starting. When the vehicle’s battery voltage drops below a preset point, the engine
will automatically start and run for the preset time to avoid a dead battery.
*Requires the optional ScyNet Network Remote Car Start Module.
21. Special Transmitter Program.* Programs the different optional transmitters into the system.
Learn FM Remote. Learns the optional 2-way FM transmitter. Press Button 2 on the 1-way remote to
enter FM Transmitter learn mode, then press transmitter Button 1 on each FM remote (max 2).
Learn Hands-Free Remote. Learns the optional Hands-Free transmitter. Press Button 3 on the standard
remote to enter Hands-Free learn mode, then press transmitter Button on each Hands-Free remote.
Note: The Hands-Free transmitter must be turned off to learn into the system.
See the Hands-Free
manual for more details.
*Requires the optional ScyNet FM LCD Pager Module.
Galaxy 3000 Plus - Page 19