Sony SLV-D910B - Manual (Page 116)

116 Troubleshooting
T
im
e
r reco
rd
in
g
The timer does not operate. • Check that the clock is set.
• Make sure a tape has been inserted.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• Make sure a programme has been set for timer recording.
• Make sure your timer settings are past the current time.
• Check that the decoder is turned on.
• Check that the satellite tuner is turned on.
• The clock stops if the DVD-VCR is disconnected from
the mains for more than one minute. Reset the clock and
timer.
• Turn the power off and unplug the mains lead.
The VPS/PDC function does not
operate properly. • Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Can
a
l P
lus
You cannot watch Canal Plus
programmes when the VCR is in
standby mode. • Check that “DEC” is set to “OUI” for this channel in the
“LISTE STATIONS TV” menu.
• Make sure the Canal Plus PERITEL cable is plugged
securely.
A Canal Plus programme is always
recorded scrambled. • Make sure the Canal Plus PERITEL cable is plugged
securely.
• Check that “DEC” is set to “OUI” for this channel in the
“LISTE STATIONS TV” menu.
Ot
he
rs
A tape cannot be inserted. • Check that a tape is not already in the tape compartment.
The selected input line connector
number does not appear in the
display window. • Press INPUT SELECT to display the connected line.
The VCR mechanism needs to be
cleaned. • Clean the cabinet, panel and controls with a dry, soft
cloth, or a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of solvent, such
as alcohol or benzine.
Symptom Remedy
Symptoms caused by contaminated video heads
• Normal picture • Unclear picture • Rough picture
initial
contamination
terminal
• No picture (or
black & white
screen appears)