Sonic Impact Technologies Larco USB Mat - Manual (Page 10)

By selecting the WinXP Classic Logon Prompt option the USB Mat will be set with:
Walk-Away: CTL-ALT-DEL+K+Backspace+Escape
Walk-To: CTL-ALT-DEL
By selecting the WinXP Welcome Screen Logon option the USB Mat will be set with:
Walk-Away: LGUI-L
Walk-To: None
Windows 98SE and Windows ME users will need to make a short-cut on the desktop to launch a
screensaver. The shortcut needs to have a shortcut key assigned to it. This key is what needs to
be assigned in the “Walk-Away” sequence. See Appendix I for this procedure.
After selecting your Quick Setting, be sure to click the “Apply” button to save your new settings.
Note: Once you have set the USB Mat with keystrokes, these keystrokes will be sent during the
next Walk-Away event. To prevent keystrokes from being sent while the configuration program is
being used, click the “Halt Key Sends” check box in the lower left corner of the application
screen. This will temporarily stop sending the keystrokes. This check box is cleared once the
application has been exited.
If you want, you can customize the key sequence by selecting the appropriate keys and modifiers for
your particular usage. For example, you may choose to place the system in the log off mode or
standby mode instead of simply locking the system. Simply configure the keystrokes to do these
functions and click the “Apply” or “OK” button to save the new settings.
The “Walk-To” configurations functions similarly. Simply customize the “Walk-To” folder entries to your
preferred settings and click the “Apply” button.
Configuration: Miscellaneous
Under the miscellaneous folder, you can perform the quick configurations, as well as, reset the unit to its
factory default settings. There is also an advanced settings tab that should only be used after speaking
with Larco technical support.
10