Sonic Impact Technologies Larco USB Mat - Manual (Page 7)

Attaching the SONIC GUARD USB Mat
If your system meets these requirements, then attaching the USB Mat in your workspace is the
next step. Connect the USB cable to an open USB port on your computer. Windows will load the
appropriate USB keyboard drivers once the USB Mat is attached. If the USB Keyboard drivers are
not currently resident on your system, you will be asked to place your Windows Operating System
disk into your CD drive. Follow the directions provided by Windows during this install.
Note:
There are no USB drivers provided on the SONIC GUARD Configuration Disk. All USB drivers will
be provided by the Windows 98SE, Windows 2000 or Windows XP operating systems.
Configuration
The USB Mat has several configurable settings that are controlled via the SONIC GUARD Configuration
program. Place the supplied SONIC GUARD Configuration CD into your CD drive and run the supplied
program (SonicGuard.exe). Click on the “Sonar” tab and you will see the screen below.
Figure 2: SONIC GUARD Sonar Configuration Screen
7