Sony CDP-CX153 - Manual (Page 15)

Playing CDs Getting Started Playing CDs
15 EN
4
Press ENTER or PROGRAM. Creating a program using the remote
TRACK
Number
buttons
ENTER
PROGRAM
DISC
(
1 Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the display.
If a program is already stored in the selected
program number, the last step of the program
appears in the display. When you want to erase the
whole program, hold down CLEAR until “ALL
CLEAR” appears in the display (see page 16).
2
Press DISC.
PROGRAM 1 CD
]
1
D _ I S C - [
3 Press the number button of the disc.
To select a disc with a number over 10
Press the 10’s digit first, then the 1’s digit. To enter 0, use
the button 10/0 (see page 10).
DISC TRACK STEP
PROGRAM 1 CD
2
1
0 A L
4
To program a whole disc, skip this step and go to
Step 6. Press TRACK.
PROGRAM 1 CD
_ ]
1
T R A C K - [
5
Press the number button of the track.
To select a track with a number over 10
Press the 10’s digit first, then the 1’s digit. To enter 0, use
the button 10/0 (see page 10).
PROGRAM 1 CD
1 ]
1
T R A C K - [
The track being programmed
Playing order The disc being
programmed
DISC TRACK STEP
2 0 1 3
5
To program other discs/tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
6
Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
When you press ·, you can play the same program
again.
When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The programs remain until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
Repeat Steps
2 and 4
3 to 4
2 to 4
(Continued)