SeaLand 111 - Manual (Page 2)

2
The model identification label is located on the toilet base
and will show the model number and serial number. Follow
instructions for removing toilet pedestal cover in “Pedestal
and Pedal Cover Installation” on page 3. If label is not
available, please refer to “Dimensional Specifications” on
page 4 for toilet model identification.
ToILeT MoDeL IDeNTIfICATIoN
1. Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, in the system. These
products damage the seals in toilets and dump valves.
2. Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc.) to be flushed through
the toilet.
3. Mechanical seal toilets, like SeaLand units, are designed to only discharge directly into a holding
tank. Horizontal pipe runs as found in conventional residential or commercial plumbing systems cannot be
accommodated.
4. Toilet must be regularly cleaned and winterized according to “Proper Bowl Cleaning” and
“Winterizing” procedures on page 4, or your warranty coverage may be voided.
IMpoRTANT INfoRMATIoN
TAbLe of CoNTeNTS
To prepare the SeaLand toilet for use, make sure water supply to the toilet
is connected. Turn on water supply and check system for leaks. Flush toilet
and check again for leaks.
Make sure the flushing instruction label (shown at right) is in plain sight and easy for
guests to read. If this label is not included in this manual, please contact the
SeaLand product Customer Service Department immediately.
To properly use the SeaLand toilet, follow these simple instructions:
.
To add water to the toilet, lift or raise the flush lever until desired
water level is reached. Generally, more water is required only when
flushing solids.
2. To flush toilet, push lever all the way down until contents leave toilet
bowl. Water flow pressures vary at different locations, therefore holding the flush lever down for 4-8 seconds
may be required. We require a minimum flow at the inlet of the toilet of 2 gpm (7.6 lpm) for proper flushing.
3. Allow flush lever to snap back, which permits positive sealing around the flush ball.
4. A small amount of water should remain in bowl.
Note: Holding flush lever down longer than necessary results in excessive water usage.
hoW To uSe
Important Information ............................................. 2
Toilet Model Identification ...................................... 2
How to Use ............................................................. 2
Installation .............................................................. 3
Pedestal and Pedal Cover Installation .................. 3
Proper Bowl Cleaning ............................................ 4
Winterizing ............................................................. 4
Dimensional Specifications..................................... 4
Deodorants and Special Tissue ............................. 5
Service Tip ............................................................. 5
Troubleshooting Guide ......................................6 - 7
Ordering Parts ........................................................ 8
Customer Service ................................................... 8
Warranty ................................................................. 8
DOMETIC CORPORATION
P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886
BIG PRAIRIE, OH 44611 USA
MODEL NO.
000
SERIAL NUMBER
000000