Smeg BQ6030 - Manual (Page 4)

12
Instructions for the Installer
CHANGING THE NOZZLES
REPLACING THE BURNER SECTION NOZZLES
1
Remove the grids and refractory plates inside the
barbecue section.
2 Undo the screws (for each burner) on the rear
cross-member.
3 Remove the burners from the barbecue section.
4 Using a 7 mm socket wrench, undo the nozzles on
the taps (replace the nozzles as specified in the
table above).
5 Adjust the primary air flows (see adjusting primary
air flows section).
6 Put the burners back into place correctly and
tighten the fixing screws.
REPLACING THE RADIANT GRILL NOZZLES (ON
TOP VERSIONS ONLY)
1
Remove the rear of the barbecue by undoing the
supporting screws.
2 Using a 7 mm spanner, unscrew the nozzle (1).
3 Replace the nozzles as specified in the table
above. To make it easier to fit the nozzle, the nut
(2) can be unscrewed.
4 Retighten the nut (2) with great care.
5 Fit the rear part back into place and screw on with
the fixing screws.
REPLACING THE ULTRARAPID BURNER NOZZLE
(BQ6030 MODELS ONLY)
1
Remove the grid, the burner cap and the flame
diffuser ring.
2 Using a 7 mm socket wrench, unscrew the burner
nozzle.
3 Replace the nozzle as specified in the table above.
4 Put the burner, the burner cap and the flame
diffuser ring back into place correctly.
5 Fit the rear part back into place and screw on with
the fixing screws.
1 2