Sony 4-183-746-11(1) - Manual (Page 62)

62
5
Make sure that the built-in flash and flash unit are fully
charged.
• “ ” is lit in the viewfinder when the built-in flash is fully charged.
• When the flash unit is fully charged in the wireless flash mode, the AF
illuminator on the front blinks, and the TEST button is lit in amber.
6
Use test-flash to check the flash.
• Make sure that the wireless remote mode of the flash unit is set to [RMT] or
[RMT2].
• During wireless flash photography, the test-flash method differs depending
on the camera used. For details, refer to the operation instructions of your
camera.
• If the test-flash does not work, change the position of the camera, flash, and
subject, or point the wireless control-signal receiver towards the camera.
7
Check again that the built-in flash and the flash unit are
fully charged, and press the shutter button to take the
photo.