Smeg SNZ414IS - Manual (Page 14)

END PROGRAM
When the program finishes, a buzzer sounds
briefly and all the PHASES/PROGRAM lights
(8) flash.
Press any of the SELECTION PROGRAMS buttons (2), stops the light
flashins, and the dishwasher is now ready to perform a new cycle;
opening and shutting the door or switching the appliance off and on has
the same effect.
15
1 2 10
6 5 7 8 9
3 4
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
• press
the START/PAUSE button (4), the light of the current phase
goes out;
• keep the button pressed until the PHASES/PROGRAM lights (8)
come on (confirmation buzzer).
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “I
NTERRUPTION OF A PROGRAM ”);
• select the new program;
• to press again the START/PAUSE button (4) to make start the new
program.
User instructions