Smeg SNZ414IS - Manual (Page 15)

ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“I
NTERRUPTION OF A PROGRAM ”).
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “S
TART PROGRAM ”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
16
Eco
P1 P2
DELAY PROGRAM
(available in all programs except the soak program)
The PROGRAM DELAY button (3) can be pressed to delay the start of
the washing program by 3, 6 or 9 hours. This function allows you to set
the dishwasher to work at your preferred time of day.
After selecting the delay, start the program (see relative section).
The appliance will prewash the dishes, after which the "program delay"
set previously will come into effect (the light corresponding to 3, 6 or 9
hours flashes).
To reset or change the delay once the program has started:
• press the START/PAUSE button (4) for a few seconds, until the
PHASES/PROGRAM lights (8) come on;
• press the DELAY PROGRAM button (3) several times “until the
program delay” returns to zero (all the lights indicating the delay go
out);
• press the START/PAUSE button (4) to start the new program.
User instructions