Samsung ML-4050ND - Manual (Page 25)

4.2
<Network setup>
Supported operating systems
The following table shows the network environments supported by the
printer:
• IPX/SPX: Internet Packet eXchange/Sequenced Packet eXchange
• TCP/IP: Transmission Control Protocol/Internet Protocol
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Configuring TCP/IP
Your printer can be set up with a variety of TCP/IP network information,
such as an IP address, a subnet mask, a gateway, and DNS addresses.
There are several ways in which your printer can be assigned a TCP/IP
address, depending on your network.
• Static addressing: A TCP/IP address is assigned manually by the
system administrator.
• Dynamic addressing via BOOTP/DHCP (default): A TCP/IP address
is assigned automatically by the server.
Static addressing
To enter a TCP/IP address from your printer’s control panel, take the
following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press OK when TCP/IP appears.
3 Press the Scroll buttons until Static appears and press OK.
Item Requirements
Network interface • 10/100 Base-TX
• IEEE 802.11 b/g Wireless LAN (optional)
Network operating
system • Novell NetWare 4.x, 5.x, 6.x
• Windows 2000/XP/2003/2008/Vista/7/
Server 2008 R2
• Various Linux OS
• Macintosh OS 8.6 ~ 9.2 and 10.1 ~ 10.6
Network protocols • NetWare IPX/SPX
• TCP/IP
• EtherTalk
• HTTP 1.1
• SNMP
Dynamic
addressing server • DHCP, BOOTP
Note
• Before configuring TCP/IP, you need to set the network
protocol to TCP/IP.
4 Press OK when IP Address appears.
5 Set the first byte between 0 and 255 using the Scroll buttons and
press OK to move to the next byte.
Repeat this to complete the address from the 1st byte to the 4th
byte.
6 When you have finished, press OK.
7 Repeat step 5 and 6 to configure the other TCP/IP parameters:
Subnet Mask and Gateway address.
8 Press Stop to return to Standby mode.
Dynamic addressing (BOOTP/DHCP)
To have a TCP/IP address assigned automatically by the server, take the
following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press OK when TCP/IP appears.
3 Press the Scroll buttons until DHCP or BOOTP appears and press
OK.
4 Press Stop to return to Standby mode.
Configuring EtherTalk
EtherTalk is AppleTalk used in an Ethernet network. This protocol is
widely used in Macintosh network environments. To use EtherTalk, take
the following steps:
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until EtherTalk appears and press OK.
3 Press the Scroll buttons until On appears and press OK.
4 Press Stop to return to Standby mode.