Samsung ML-4050ND - Manual (Page 59)

10.2
<Installing accessories>
3 Grasp the control board cover and remove it.
4 Completely open the latches on each side of the DIMM slot.
5 Remove the memory DIMM from its antistatic package. Locate the
alignment notches on the bottom edge of the DIMM.
6 Holding the memory DIMM by the edges, align the notches on the
memory DIMM with the grooves on the memory DIMM slot.
7 Push the DIMM straight into the DIMM slot until it snaps into place.
Make sure the latches fit over the notches located on either side of
the DIMM.
Notches
Connection
Points
Latch
8 Close the control board cover by aligning the groove on it with the
notch on the printer and sliding it.
9 Reinstall the duplex-slot cover or the duplex unit.
10 Reconnect the power cord and printer cable, and turn the printer
on.
Setting the memory in the PostScript printer
properties
After installing the DIMM, you need to select it in the printer properties of
the PostScript printer driver to enable its use.
1 Make sure that the PostScript printer driver is installed on your
computer. To install the PostScript printer driver, see the Software
section.
2 Click the Windows Start menu.
3 For Windows 2000, select Settings and then Printers.
For Windows XP/2003, select Printers and Faxes.
For Windows Vista/2008, select Control Panel > Hardware and
Sound > Printers.
For Windows 7, select Control Panel > Hardware and Sound >
Devices and Printers.
For Windows Server 2008 R2, select Control Panel > Hardware >
Devices and Printers.
4 Select the Samsung ML-4050 Series PS printer.
5 Click the right mouse button on the printer icon and select
Properties.
6 Select the Device Settings tab.
7 Select the amount of memory you installed from Printer Memory in
the Installable Options section.
8 Click OK.