Star Micronics SP300 Series - Manual (Page 30)

– 26 –
This printer can print one line of validation printing.
5-1. Operating Method
5. VALIDATION PRINTING (Models with validation function only)
Fig. 5-2 Loading the paper
1 Open the front cover, pull the adjust
lever one notch from standard posi-
tion A toward the operation panel
side position B.
When you cannot find standard po-
sition A, push the lever as far as
possible toward the rear cover, and
pull it 2 notches after having pressed
it down. The lever is now in standard
position A.
2 Mount the front cover.
3 Set the printer for the validation
print mode. In this instance, the
buzzer gives tow short beeps.
A: Standard position (one sheet)
B: Validation printing or copying
A
B
Adjust lever
4 Make sure that the ON LINE lamp
is flashing.
5 Align the right edge of paper with
the right end of the tear bar then
insert the paper from the top.
6 The printer starts printing approx. 1
second after the paper is loaded.
7 When printing is completed, pull
the paper upward and remove it
from the printer.
Note: When printing a roll paper, also
set the adjust lever at position B.
Fig. 5-1 Position of the adjust lever
POWER
ALARM
ON LINE
FEED
Rear cover
Front cover
Right end
of the tear bar