0 max functions menu, 0 zoom type, 1 fonts & symbols – Standard Horizon CP500 User Manual
Page 35: Fonts & symbols, Map functions, Zoom type, Max functions menu 6.0.0
CP500
Page 37
6. MAP FUNCTIONS
6.0
MAX FUNCTIONS MENU
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right. The MAX Functions menu appears on the screen:
Figure 6.0 - Max Function Menu
The available Functions are described in the following.
6.0.0 Zoom Type
Allows zooming into our out on the chart page. Zoom Mode has two options; STANDARD
(default) or FLEXI-ZOOM. When in FLEXI-ZOOM mode, a short [ZOOM...] push causes
a change of chart, while a long [ZOOM...] push (press and hold) causes a pop-up window
to be displayed on a corner of the screen. The window shows the current Zoom Factor. By
pressing [ZOOM IN]/[ZOOM OUT] the map is expanded or compressed according to the
zoom factor selected. The window is automatically closed if [ZOOM...] is not pressed for 2
seconds and the selected zoom factor will be used at the next zoom in/out.
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight ZOOM TYPE and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD or FLEXI-ZOOM.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.1 Fonts & Symbols
On MAX charts it is possible to set the size of all names and symbols drawn on the charts,
selecting between Normal size (the regular characters size) and Large size.
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight FONTS & SYMBOLS and press [ENT] or move
the ShuttlePoint knob to the right.