SIIG 04-0265F User Manual
Page 6
6
6.
Check Specify a location, uncheck the other box,
type D:\ME, click Next. (Change D: to match the
drive letter of your CD-ROM)
7.
Click Next, then click Finish. Remove the driver CD
and restart Windows to complete the installation.
For Existing Windows ME Installation
1.
Install the board and boot up Windows ME.
2.
At the Add New Hardware Wizard, insert the driver
CD.
3.
Select Specify the location of the driver (Advanced),
then click Next.
4.
Check Specify a location, uncheck the other box,
type D:\ME, click Next. (Change D: to match the
drive letter of your CD-ROM)
5.
Click Next, then click Finish.
6.
Remove the driver CD and restart Windows to
complete the installation.
To Verify Windows 98SE/ME Installation
1.
Right-click My Computer, then click Properties.
Select Device Manager tab.
2.
Double click SCSI controllers, Silicon Image SiI...
Controller should be listed.
3.
Double click Silicon Image SiI... Controller and
click Properties. A message This device is working
properly is displayed in the dialog box when the
driver is correctly installed.