Sony Ericsson CDP-CX220 User Manual
Page 12
– 12 –
Aging Method
1. Change the
[COMMAND MODE]
switch (S901) on set to
[CD1]
.
2. Turn ON the power of the unit. Open the front cover.
3. Press the
[AGING START]
button of the remote commander
for aging mode (J-2501-123-A).
4. When the disc set mode is set, the
· and P LEDs blink.
5. Rotate the JOG dial. The slits (No. 40, 80, 120, 160, 200) for
setting the discs will come forward. Insert the discs into these
slits. Do not set the discs in other slits.
6. Set whether the self-protection function during errors is
equipped with the unit. Press the
[REPEAT]
button. If “RE-
PEAT” is displayed on the Fluorescent indicator tube, it means
the function is provided. If “REPEAT” is not displayed, it
means the function is not provided.
7. Press the
· button.
8. The
· LED blinks, the aging mode is set, and aging is
started.
9. The aging cycle lasts 3 minutes. If errors occur during aging,
the error number will be displayed on the Fluorescent indica-
tor tube. (Refer to the following table for the details of the
errors.)
10. Aging will be repeated as long as no errors occur.
11. After each aging cycle, the number displayed on the Fluores-
cent indicator tube will increase.
12. To end aging, press the
I/
u button
Error Display
Error code
1 2 0
E r r 0 1
Disc number
Error code
Code number
Name
Contents
Err 01
DISC sensor check 1
No disc in the specified slit
Err 02
DISC sensor check 2
Disc in other slits
Err 03
Table operation check 1
Table motor current over
Err 04
Table operation check 2
No table sensor input
Err 05
Loading operation check 1
Load in timeover
Err 06
Loading operation check 2
Load out timeover
Err *1
BU related check 1
Access timeover
Err *2
BU related check 2
High speed search NG
Err *3
BU related check 3
Q data read error
Err *4
BU related check 4
BU operation (from focus search to until signal can be read) timeover
Err *5
BU related check 5
GFS monitor error
Err *6
BU related check 6
Focus cannot be imposed by focus search
Err *7
BU related check 7
Auto focus bias adjustment cannot be performed
The * numbers mean the following according to the state of the unit during aging
2 : From checking to end of TOC read
3 : From end of TOC read to end of last track playback
4 : From end of last track playback to end of first track playback