Snapper 1685336 - Manual (Page 2)

Figure 3. Diagrams of Hitch Templates
6. Assemble the chain (D, 1) to the tractor as
follows:
42” Blade on Group 1 and 2
On left-hand side, remove and discard the upper
self-tapping screws that holds bumper to frame.
This is the hole used for installing chain in the
following steps, using
16-18
(C), two 16 washers (B) and one 16 locknut
Place one 16 washer onto the Then
place the chain on the and then the
other 16 washer:
Insert the (A, figure 4) through tractor
frame. From inside the frame, install 16 locknut
onto capscrew. Tighten snug only at this time.
(Spring (B) will be installed in step 7.)
Figure 4. Chain Installation (Group 2 Tractor
Shown)
A.
Spring
42” Blade on Group 3 and 4; 46” Blade on Group 4
a. On the left hand side, remove the front hood pivot
bolt.
b. Chain must be installed with the following
hardware (not included in this kit):
c . Place one washer onto capscrew. Place link of
chain (42” blade on Group 3 tractor) or second
link of chain
blade on Group 4 tractor)
on Install final two washers on
d. Insert (A, figure 5) through tractor
frame. Tighten snug only this time. (Spring,(B)
will be installed in step 7.) the frame,’
install locknut.
Figure 5. Chain Installation (Group 3 Tractor
Shown)
A.
Spring
46” Blade on Group 3
a. The chain is not used to secure spring to tractor
frame. Spring is installed directly to tractor
frame.
b. Drill a hole in the front of frame in
from the front left side and up from the
bottom of the frame. Refer to 6.
Figure 6. Spring Installation (Group 4 Tractor
Shown)
Blade Tractor Hardware Number
42” Group 3 1 1922130
7. Raise the push bar and hook up one end of spring to
chain or frame as shown in figures 7A through 7F.
Hook other end of spring to hole drilled in hitch cross
member (figure or top front plate (figure
, 3 1 6 2 2 7 6 6
4 2 ” Group 4 1 1 9 2 1 9 6 9
4 6 ” 3 Washer