Sennheiser SR 2050 IEM - Manual (Page 13)

Putting the transmitter into operation
12
Connecting devices to the output sockets
̈
Use a suitable cable to connect the audio input of a device (e.g. a mixing console or an
additional SR 2000 IEM or SR 2050 IEM) to the output socket
LOOP OUT BAL L(I)
Ƹ
and/
or LOOP OUT BAL R(II)
ƹ
(see preceding chapter).
Connecting transmitters in a network
You can connect several transmitters in a network. The transmitters are remote controlled via
a PC running the “
Wireless Systems Manager ” (WSM) software. This software will assist in
the quick and safe configuration of multi-channel systems.
̈
Connect a standard network cable (at least Cat 5) to the LAN socket
¹
of the transmitter.
̈
Connect your transmitters to an Ethernet switch.
̈
Connect a PC to the Ethernet switch.
When a transmitter is properly connected to the Ethernet switch or the PC, the yellow
LED
¸
at the rear of the transmitter lights up.
For further information on network operation, refer to page 22.
Connecting the mains cable
̈
Pass the mains cable through the cable grip
µ
.
̈
Connect the mains cable to the mains socket
¾
.
̈
Plug the mains plug into the wall socket.
ETHERNET RJ-45
B
RF OUT
ANT B
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 627945
SER NO 251810043 FMO
IC 2099A-SR20x0
Stereo Transmitter SR 2000 IEM
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 503841
SER NO 2518100095 FMO
IC 2099A-SR20x0
L(I) R(II)
+22dBu
MAX
Loop Out A
BAL
Ƹ ƹ ƺ The signal received from the AF input sockets BAL AF IN L(I)
ƺ
and BAL AF IN R(II)
ƻ
is actively buffered and then routed to the output sockets LOOP OUT BAL L(I)
Ƹ
and
LOOP OUT BAL R(II)
ƹ
. The AF output sockets will therefore work only when the trans-
mitter is switched on and powered.
The “ Wireless Systems Manager ” (WSM) software can be downloaded from the
corresponding product page on our website at www.sennheiser.com.
ETHERNET RJ-45 RF OUT
ANT B
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 627945
SER NO 251810043 FMO IC 2099A-SR20x0
Stereo Transmitter SR 2000 IEM
DESIGNED AND MADE IN GERMANY
FREQ RANGE-Dw
790-865 mHz
ART NO 503841
SER NO 2518100095 FMO
IC 2099A-SR20x0
L(I) R(II)
+22dBu
MAX
Loop Out A
BAL
¹ ¸
CAUTION! Damage due to electric current!
If you connect the transmitter to an unsuitable power supply, this can cause damage to the
device.
̈
Use the supplied mains cable to connect the transmitter to the mains (100 to 240 V AC,
50 or 60 Hz).
̈
Ensure a reliable mains ground connection of the transmitter – especially when you are
using multi-outlet power strips or extension cables.
50/60Hz 0.2 A ETHERNET RJ-45
B
100 - 240V
¾ µ