Sennheiser SR 2050 IEM - Manual (Page 17)

Using the transmitter
16
When carrying out the Sync function, the transmitter’s current frequency bank and
channel setting as well as the receiver parameters adjusted via the “ Sync Settings ”
submenu are transferred to the EK 2000 IEM receiver via the infra-red interface.
Carrying out an Easy Setup Sync or a Sync function
The following assumes that you are using the Easy Setup Sync function for setting up a multi-
channel system. You can also you the Easy Setup Sync function for establishing a transmis-
sion link between one transmitter and one EK 2000 IEM receiver.
Easy Setup Sync Sync
̈
Switch all transmitters and one diversity
receiver on.
̈
Switch your transmitter and your
diversity receiver on.
̈
On all transmitters, call up the “ Easy
Setup ” menu item.
The text “ Easy Setup Sync ” and the
icon appear on the display panels of the
transmitters.
The RF signal of the transmitters is auto-
matically deactivated.
̈
Press the button
¿
on the trans-
mitter.
The
icon appears on the display
panels of the transmitter.
̈
Use your diversity receiver to perform a
frequency preset scan and select a
channel within a frequency bank with a
sufficient number of unused channels (see
the instruction manual of the receiver). –
̈
Place the infra-red interface of the
receiver (see the instruction manual of
the receiver) in front of the infra-red
interface
´
of the first transmitter.
The next unused frequency preset is
transferred
from the receiver to the
transmitter .
As soon as the transfer is completed, the
display panel of the transmitter displays
the numbers of the transferred fre-
quency bank and channel.
Please note that the transmitter does not
automatically store the frequency bank
and channel setting.
̈
Place the infra-red interface of the
receiver (see the instruction manual of
the receiver) in front of the infra-red
interface
´
of your transmitter.
The parameters adjusted via the “ Sync
Settings ” menu item are transferred
from the transmitter to the receiver .
In addition, the current frequency bank
and channel setting is transferred.
When the transfer is completed, “ ”
appears on the display panel of the trans-
mitter. The transmitter then switches
back to the standard display.
The transferred parameters are automat-
ically adjusted and stored by the receiver.
The transmission link between trans-
mitter and receiver is now established.
OFF 2 4 6
PHONES
´
OFF 2 4 6
PHONES
ᕥ
ᕤ