Sony RM-LJ312 - Manual (Page 28)

Sony Corporation Printed in Malaysia
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
The remote does not function.
• If the receiver’s COMMAND MODE and the
remote’s COMMAND MODE do not match,
transmission is not possible between the remote
and the receiver (page 26).
• Make sure that the model name appears correctly
on the AMP REGIST list. If “? ? ?” appears on the
list, perform the procedure of AMP REGIST
(page 6).
• Point the remote at the remote sensor on the
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct input on the
remote.
• When “2ND ZONE” or “3RD ZONE” appears, or
when the sound fields are not fully displayed,
check if the remote is registered for the receiver
correctly.
• When you operate a programmed non-Sony
component, the remote may not function properly
depending on the model and the maker of the
component.
E appears in the display window of the
remote.
• The batteries are running out. Replace all the
batteries with new ones.
The input names that appear in the display
windows of the receiver and the remote are
different.
• Select the correct input using the remote.
General
Remote control system Infrared control
Power requirements 4.5 V DC with three R6
(size-AA) batteries
Dimensions 175 Ч 63 Ч 30 mm
Mass (approx.) 125 g excluding batteries
Design and specifications are subject to change
without notice.
Additional Information
Troubleshooting
Specifications