Smart Inventions Smart Table tm 230i kb141081 - Manual (Page 16)

8 | CHAPTER 2 – USING YOUR SMART TABLE
Turning your SMART Table on or off
After you set up your SMART Table, you can turn it on or off by following these
procedures.
Turning on your SMART Table
To turn on
your SMART Table
1. Connect the power cable to an outlet or connect it to a power bar, and then turn on
the power bar.
NOTE
SMART recommends connecting the power cable to a power bar.
2. Push the Reset switch located on the side of the table.
Your SMART Table’s computer and projector
turn on. The computer completes its startup
process, and the SMART Table Activities
menu appears.
IMPORTANT
Avoid touching the table surface until the
projector starts up and an image appears.
Because the table is touch-sensitive even
though you cannot see an image, you may disrupt or open activities
unintentionally.
Reset switch
USB connectors