Smart Inventions Smart Table tm 230i kb141081 - Manual (Page 23)

15 | CHAPTER 4 – USING THE REMOTE CONTROL
To replace the remote
control battery
1. Place your fingernail on the groove of the battery holder
on the back of the remote control (1).
2. While holding down the release on the side (2a),
pull out the holder (2b).
3. Remove the old battery from the battery holder.
4. Place the new battery in the battery holder.
WARNING
Ensure the + side of the battery is facing up (so
that you can see it). Do not install the battery
upside down.
5. Place the battery holder back in the remote control, and
then push it in until it clicks into place.
1
2b
2a