Sony UP-DF500 - Manual (Page 19)

A
d
jus
tment
Menu Operation
19
3 Display the selected number by pressing the G
or g button.
To reset to the default setting of the high
tone range
Display 75.
Selecting a Gamma Curve
When the gamma curve is not specified at the modality
side, select the gamma curve to be used at the unit.
1
Press the MENU button.
2
Display the GAMMA SEL menu by pressing the F
or f button, then press the g button.
The unit enters the gamma selecting mode.
3
Select the desired gamma curve by pressing the G
or g button.
The gamma curves for SONY 1 to SONY 5 have
been pre-set, you cannot change these settings.
The gamma curves for USER 6 to USER 10 can be
set to the desired value. For advice on the settings,
contact your nearest Sony dealer.
Gamma curve
The gamma curves of SONY 1 to SONY 5 are
shown below.
Display the selected number.
3 1
2
4
Gamma curve Meaning
SONY 1 Default setting
SONY 2 The half tone is darker compared to
SONY 1
SONY 3 The half tone is lighter compared to
SONY 1
SONY 4 The half tone is smoother compared to
SONY 1
SONY 5 The half tone is sharper compared to
SONY 1
USER 6 to 10 Not preset. For advice on settings,
contact your nearest Sony dealer. If
you select these gamma curves,
USER 6 to 10 before setting, same
setting as the one of SONY 1 is
applied.
Light
Input data
Dark
Printout
Light
Dark