Samsung P63FP-2 - Manual (Page 106)

Note
Design and specifications are subject to change without prior notice.
Class B (Information Communication equipment for residential use)
This device is registered for EMC requirements for home use (Class B). It can be used in all
areas.
(Class B equipment emits less electromagnetic waves than Class A equipment.)
PowerSaver
This PDP Display has a built-in power management system called PowerSaver. This system
saves by switching your PDP Display to low-power mode when it has not been used for a
certain amount of time. The PDP Display automatically returns to normal operation when you
press a key on the keyboard. For energy conservation, turn your PDP Display OFF when it
is not needed, or when leaving it unattended for long periods. The PowerSaver system op-
erates with a VESA DPM compliant video card installed in your computer. Use the software
utility installed on your computer to set up this feature.
PowerSaver
State Normal Opera-
tion
Power saving
mode
Power off
Power Indicator On Blinking Off
Power
Con-
sumption
(Typical)
MD230 P50HP,
P50HP-2
The power
consumption
may differ de-
pending on the
region. Refer
to the label on
the back of the
product.
2 watts 0 watt
P63FP,
P63FP-2
The power
consumption
may differ de-
pending on the
region. Refer
to the label on
the back of the
product.
2 watts 0 watt
Note
• The actual power consumption may be different from the indicated power consumption if
the system condition or settings are changed.
• To stop any power consumption, disconnect the power cable on the back. Be sure to
disconnect the power if you intend to stay away from home for many hours.
Preset Timing Modes
If the signal transferred from the computer is the same as the following Preset Timing Modes,
the screen will be adjusted automatically. However, if the signal differs, the screen may go
blank while the power LED is on. Refer to the video card manual and adjusts the screen as
follows.
Specifications
80