Sioux Tools TURBO-MAX 6056 - Manual (Page 8)

Page 8
Be a safe and courteous driver. Always yield to oncoming traffic in all situations, including narrow bridges, inter-
sections, etc.
Be observant of bridge load ratings. Do not cross bridges rated lower than gross weight at which you are operat-
ing.
Watch for obstructions overhead and side to side while transporting.
Always operate equipment in a position to provide maximum visibility. Make allowances for increased length and
weight of equipment when making turns, stopping unit, etc.
•
•
•
•
Good maintenance is your responsibility. Poor maintenance is an invitation to trouble.
Make sure there is plenty of ventilation. Never operate engine in a closed building. Exhaust fumes may cause
asphyxiation.
Before working on this machine, stop vehicle, set brakes, shut off engine and remove ignition key.
Always use safety support and block wheels. Never use a jack to support machine.
Always use proper tools or equipment for job at hand.
Use extreme caution when making adjustments.
Follow torque chart in this manual when tightening bolts and nuts.
Never use your hands to locate a hydraulic leak on attachments. Use a small piece of cardboard or wood. Hydraulic
fluid escaping under pressure can penetrate skin.
Openings in skin and minor cuts are susceptible to infection from hydraulic fluid. without immediate medi-
cal treatment, serious infection and reactions can occur.
When disconnecting hydraulic lines, shut off hydraulic supply and relieve all hydraulic pressure.
Replace all shields and guards after servicing and before moving.
After servicing, be sure all tools, parts and service equipment are removed.
Do not allow grease or oil to build up on any steps or platform.
When replacing bolts, refer to owners manual.
Refer to bolt torque chart for head identification marking.
Where replacement parts are necessary for periodic maintenance and servicing, genuine factory replacement
parts must be used to restore your equipment to original specifications. Manufacturer will not claim responsibility
for use of unapproved parts or accessories and other damages as a result of their use.
If equipment has been altered in any way from original design, manufacturer does not accept any liability for injury
or warranty.
A fire extinguisher and first aid kit should be kept readily accessible while performing maintenance on this equip-
ment.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
PERFORmING mAINTENANCE