Scientific Atlanta VCR Commander - Manual (Page 7)

7
Installing the IR Blaster , Continued
Attaching the IR Blaster to Your VCR
1. Refer to your VCR user’s guide
to locate the IR sensor window.
(The IR sensor is where the VCR
receives the remote control signal.)
2. Remove the covering on the
adhesive strip from the loop
tape, which is attached to the
hook fastener on the IR
Blaster.
Notes:
• Attaching the IR Blaster to
the VCR may be easier if the
loop tape remains attached
to the hook fasteners.
• After attaching the IR Blaster to the VCR, the hook
and loop fastener allows you to easily remove the IR
Blaster for cleaning or to move the VCR.
3. Mount the IR Blaster within 3 inches of the IR sensor on your
VCR by pressing the IR Blaster against your VCR to secure it.
Notes:
• A , B, C, and D are typical places where the IR Blaster can
be attached (within 3 inches of the IR sensor on your VCR).
• Do not block the tape insert door on your VCR.