Samsung SHR-5040 - Manual (Page 58)

54_ appendix
4. name:
Input the name of site which camera is installed.
5. Brightness/contrast/hue :
Change the setting for the brightness, contrast, hue.
6. default:
Make initial setting of brightness, contrast, hue.
7. Apply to:
To selected channel setting value can be applied to all
or just selected channels.
8. Picture:
It shows picture which you select.
 Please check adjustment of camera and
monitor because Brightness/Contrast/Hue can
not use for change a picture.
PtZ
You can control PTZ or Speed dome which is connected
DVR system or external device. To use this device, install
RS485 to external device, then set up this device.
1. camera:
Displays the setup camera channel.
2. Model:
Displays the setup PTZ or the model of the speed
dome.
3. BPs:
Displays the setup PTZ transferring speed.
4. Address:
Displays the PTZ address.
reCording
recording setup
Recording information (Recording Frame rate, Quality,
Resolution, Event Record Frame rate) can be set up by
time and by recording type.
1. Frame:
It can adjust frame number of normal recording.
2. Quality:
It can adjust recording quality.
3. resolution:
It can adjust recording display size.
4. event record Frame:
It can adjust the number of record frame when “Alarm
In” or “Motion” happen.
 The normal record if frame rate should be set
less or equal to the event recording frame rate.
   
   
SHR-5042_Eng_02.indd 54 2008-01-25 오전 9:31:40