Sony STR-DH100 - Manual (Page 19)

19 GB
P
lay
b
a
ck
To activate the muting function
Press MUTING.
The muting function will be canceled when
you do the following.
• Press MUTING again.
• Increase the volume.
• Turn off the receiver.
You can enter a name of up to 8 characters for
inputs and display it on the receiver’s display.
This is convenient for labeling the jacks with
the names of the connected components.
1
Press the input button to select
the input you want to create an
index name for.
You can also use INPUT SELECTOR on
the receiver.
2
Press AMP MENU.
“BALANCE” appears on the display.
3
Press V/v repeatedly to select
“NAME IN”, then press or b.
The cursor flashes and you can select a
character.
4
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press
B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
5
Press .
The name you entered is registered.
Enjoying sound from the
components connected to
the DIGITAL MEDIA PORT
The DIGITAL MEDIA PORT (DMPORT)
allows you to enjoy sound from a portable
audio source or computer by connecting a
DIGITAL MEDIA PORT adapter.
The DIGITAL MEDIA PORT adapters are
available for purchase depending on the area.
For details on connecting the DIGITAL
MEDIA PORT adapter,
see “Connecting
audio components” (page 13).
Notes
• Do not connect an adapter other than the DIGITAL
MEDIA PORT adapter.
• Before connecting cords, make sure to disconnect
the AC power cord (mains lead).
• Do not connect or disconnect the DIGITAL
MEDIA PORT adapter while the receiver is turned
on.
• Depending on the DIGITAL MEDIA PORT
adapter, video output may not be possible.
• Depending on the type of DIGITAL MEDIA
PORT adapter, you can operate the connected
component by using the remote. For details on the
remote button operation, see page 9.
• Be sure you have made the video connection from
DIGITAL MEDIA PORT adapter to the TV (page
13).
1
Press DMPORT.
You can also use the INPUT SELECTOR
on the receiver to select “DMPORT”.
2
Start playback of the connected
component.
The sound is played back on the receiver
and the image appears on the TV.
For details, refer to the operating
instructions supplied with the DIGITAL
MEDIA PORT adapter.
Naming inputs