Sharp MD-MT877 - Manual (Page 22)

22
Basic Operation
–
Recording
–
Recording (continued)
TOC display
About the TOC
After any recording or editing function “TOC” (Table Of
Contents) is displayed. To finalize the recording or editing
function, press the •
■ / :OFF button. During this process
“TOC” will flash and “TOC EDIT!” will be displayed.
During any recording or editing function the MiniDisc unit
lid is locked, the MiniDisc cannot be removed until the pro-
cess is finalized.
Warning:
If the power is removed (Battery/AC adaptor) while “TOC”
is displayed, the MiniDisc unit lid will remain locked until
the battery/main power is restored and the unit is turned
on. Your new recordings or edited changes will be lost and
your MiniDisc may become unusable.
Caution:
While “TOC” or “TOC EDIT!” is displayed, follow the in-
structions below.
– Do not jerk or bump the unit.
– Do not unplug the AC adaptor.
– Do not remove the rechargeable battery or an alkaline
battery.
– Do not subject the unit to shock.
Otherwise, tracks may not be recorded properly.
To interrupt recording
Press the
06
button.
● To resume recording, press the
06
button again.
● The track number will be increased by one each time
the recording is interrupted.
To stop recording
Press the •
■ / :OFF button.
● When recording stops, “TOC” appears (Table Of Con-
tents). While “TOC” appears the MiniDisc recorded
contents have not yet been updated.
● To prevent the new recording from being lost it is not
possible to remove the MiniDisc while “TOC” is dis-
played.
To update the recorded contents of the MiniDisc
Press the •
■ / :OFF button while in the stop mode.
● The power turns off after recorded contents have been
updated on the MiniDisc.