Smart Parts 100 s - Manual (Page 2)

This houshold sewing machine is designed to comply with
IEC/EN 60335-2-28 and UL1594
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be
followed, including the following:
Read all instructions before using this household sewing machine.
DANGER - To reduce the risk of
electric shock:
• A sewing machine should never be left unattended when plugged in. Always
unplug this sewing machine from the electric outlet immediately after using and
before cleaning.
• Always unplug before relamping. Replace bulb with same type rated
10W (110-120V), 15W (220-240V).
WARNING
- To reduce the risk of
burns, fi re, electric shock, or injury to
persons:
• Do not allow to be used as a toy. Close attention is necessary when this sewing
machine is used by or near children or infi rm person.
• Use this sewing machine only for its intended use as described in this manual.
Use only attachments recommended by the manufacturer as contained in this
manual.
• Never operate this sewing machine if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the sewing machine to the nearest authorized dealer or service center for
examination, repair, electrical or mechanical adjustment.
• Never operate the sewing machine with any air openings blocked. Keep
ventilation openings of the Sewing machine and foot controller free from the
accumulation of lint, dust, and loose cloth.
• Keep fi ngers away from all moving parts. Special care is required around the
Sewing machine needle.
• Always use the proper needle plate. The wrong plate can cause the needle to
break.
• Do not use bent needles.
• Do not pull or push fabric while stitching. It may defl ect the needle causing it to
break.
• Switch the sewing machine off (“0”) when making any adjustment in the needle
area, such as threading needle, changing needle, threading bobbin, or changing
presser foot, etc.
• Always unplug the sewing machine from the electrical outlet when removing
covers, lubricating, or when making any other user servicing adjustments
mentioned in the instruction manual.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or where oxygen
is being administrated.
• To disconnect, turn all controls to the off (“0”) position, then remove plug from
outlet.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
SAVE THESE INSTRUCTIONS