Sennheiser EK 300 IEM - Manual (Page 16)

15
Adjusting settings via the operating menu
Scanning for, releasing and selecting frequency presets –
“Easy Setup”
Selecting the frequency bank and the channel – “Frequency Preset”
Overview of the frequency banks and channels:
Entering a name – “Name”
Via the “ Name ” menu item, you can enter a freely selectable name (e.g. the
name of the performer) for the receiver. The name is displayed on the
“
Frequency/Name ” standard display (see page 10). The name can consist
of up to 8 characters such as:
• letters (without pronounciation marks),
• numbers from 0 to 9,
• special characters and spaces.
To enter a name, proceed as follows:
Menu item Function of the menu item
Reset List Releases all locked frequency presets
Current List Selects an unused frequency preset
Scan New List Automatically scans for unused receiving frequencies
(frequency preset scan)
If receiving frequencies are used, they will be locked; if
receiving frequencies are unused, they will be released.
After the frequency preset scan, you can select an unused
frequency preset.
When setting up multi-channel systems, please observe the
following:
Only the factory-preset receiving frequencies within one
frequency bank (“
1 ” to “ 20 ”) are intermodulation-free. It is vital
to observe the notes on frequency selection on page 20.
Frequency bank Channels Type
“ 1 ” to “ 20 ” up to 16 per
frequency bank System bank:
frequencies are factory-preset
“ U1 ” to “ U6 ” up to 16 per
frequency bank User bank:
frequencies are freely selectable
̈
Press the rocker button to select a character.
̈
Press the SET button to change to the next segment/character
or to store the complete entry.
Menu
B.Ch: 1. 1
Frequency Preset B.Ch:
863.100MHz
Frequency Preset
1 . 1 B.Ch:
Frequency Preset
“Stored”
SET SET
SET
6. 3
824.500MHz
Call up “Frequency
Preset”
Select the frequency
bank and confirm
Select the channel;
store the setting
Menu
L i c h a e l
Name
Name Name
L i c h a e l M i chael
“Stored”
Call up “Name” Enter a character
and confirm
Enter a character;
store the setting
SET