Standard Horizon VHF/FM Marine Handheld Transceiver HX600S - Manual (Page 37)

HX600S Page 35
dt dt dt dt dt (DUAL WATCH MODE)
Function: Selects dual or tri-watch as desired.
Available Values: d- (Dual Watch) / t- (Tri Watch)
Default: d-
dr dr dr dr dr (DIMMER)
Function: Setting of the Display brightness level.
Available Values: 00 / 01 / 02 / 03
Default: 02
PC PC PC PC PC (AUDIO PITCH CONTROL)
Function: This control changes the speaker audio to have a high or lower
sounding pitch to assist listening in quiet or noisy environments.
Available Values: ON / OFF
Default: OFF
SOS SOS SOS SOS SOS (STROBE)
Function: Selects the S.O.S STROBE illumination from Continuously on to
SOS strobe.
Available Values: Continue / SOS
Default: SOS
StP StP StP StP StP (AM STEP)
Function: Selects the AM Band frequency step size.
Available Values: 10kHz or 9kHz (for Europe)
Default: 10kHz
rEg rEg rEg rEg rEg (MMSI REG)
Function: Stores MMSI ID code.
Note: The MMSI can only be inputted twice. If entered more than twice, the
HX600S will have to be sent to STANDARD HORIZON factory service to
reset the MMSI.
nA1 - nA6 nA1 - nA6 nA1 - nA6 nA1 - nA6 nA1 - nA6 (NOAA Weather SAME Area 1 - 6)
Function: Stores NOAA Weather SAME AREA code.
The HX600S is capable of being programmed with 6 areas or your choice to
receive SAME messages. To enable the SAME function the HX600S must
be programmed with a 6 digit SAME code for the state and county you want
to receive alerts. After the code(s) are programmed the HX600S will ONLY
respond to messages encrypted with the specific state/county that has been
programmed.