Sunbeam EM8900 - Manual (Page 32)

Descaling continued
Note: Depending on the size of the container
under the group head on occasion this may
need to be emptied throughout this process.
8. After half the solution has cycled through
press the ‘MANUAL’ button to stop the
flow and then press the ‘POWER’ button
to turn the machine off.
9. Leave the machine off for 10-15 minutes
to allow the descaler solution to take
affect.
10. Press the ‘POWER’ button once to turn
the espresso machine on.
11. Press the ‘MANUAL’ button and allow the
remaining solution to cycle through the
group head.
12. Remove the water reservoir from the
machine and rinse thoroughly under
running water, ensuring that all traces
of the descaling solution is removed.
Fill with clean water and replace the
reservoir.
13. Press the ‘MANUAL’ button and allow the
entire water reservoir to cycle through the
group head.
Note: As a safety mechanism the espresso
machine is programmed to automatically stop
the water flow after 240mls, therefore you
will need to press the ‘MANUAL’ button again
to restart the water flow.
Note: Depending on the size of the container
under the group head on occasion this may
need to be emptied throughout this process.
14. When this is finished remove the
container under the group head and give
the machine a good wipe over.
15. Carefully replace the brewing filter/shower
screen to the group head.
Important: Ensure the screw is tightened well.
16. Fill the water reservoir with fresh water
and position it on to the machine.
31