Sony CDX-C6850 - Manual (Page 25)

25
Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating started on the
original fuse. If the fuse blows, check the
power connection and replace the fuse. If the
fuse blows again after replacement, there may
be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. In order to prevent this,
open the front panel by pressing
(OPEN), then
detach it and clean the connectors with a
cotton swab dipped in alcohol. Do not apply
too much force. Otherwise, the connectors may
be damaged.
Main unit
Back of the front panel
Notes
•
For safety, turn off the engine before cleaning
the connectors and remove the key from the
ignition switch.
•
Never touch the connectors directly with your
fingers or any metal device.
Fuse (10 A)
Dismounting the unit
1
Press the clip inside the front cover with
a thin screwdriver, and gently pry the
front cover free.
2
Repeat step 1 on the left side.
The front cover is removed.
3
Use a thin screwdriver to push in the clip
on the left side of the unit, then pull out
the left side of the unit until the catch
clears the mounting.
4
Repeat step 3 on the right side.
5
Slide the unit out of the mounting.