Sony STR-DE697 - Manual (Page 50)

masterpage:Left
lename[E:\SEM_Janet\Data_STR-
DE697_revised\J9040016_4252272312DE697GB\4252272312\GB09ADD_STR-DE697-
CEL.fm]
50 GB
model name1[STR-DE697]
[4-252-272-31(2)]
Remote control
The remote does not function.
• Point the remote at the remote sensor on the
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct input on the
remote.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC. XXXX”
is set to “DEC. PCM”. Set to “DEC. AUTO”.
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
Amplifier section
Power Output
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 100 W/ch
CENTER
2)
: 100 W
SURR
2)
: 100 W/ch
SURR BACK
2)
: 100 W/ch
Models of area code SP
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 10%)
FRONT
2) : 120 W/ch
CENTER
2)
: 120 W
SURR
2)
: 120 W/ch
SURR BACK
2)
: 120 W/ch
Models of area code AU
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
80 W + 80 W
1)
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output 1)
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
2)
: 80 W/ch
CENTER
2)
: 80 W
SURR
2)
: 80 W/ch
SURR BACK
2)
: 80 W/ch
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 100 W/ch
CENTER
2)
: 100 W
SURR
2)
: 100 W/ch
SURR BACK 2) : 100 W/ch
(8 ohms 1 kHz, THD 10%)
FRONT
2) : 120 W/ch
CENTER
2)
: 120 W
SURR
2)
: 120 W/ch
SURR BACK
2)
: 120 W/ch
To clear See
All memorized settings page 17
Customized sound fields page 36
Specifications
GB01COV_STR-DE697-CEL.book Page 50 Friday, April 2, 2004 12:21 PM