Schneider Electric 100BASE-FX - Manual (Page 2)

Warning
If warning notices are ignored, severe
injury and/or material damage may occur.
Only appropriately qualified staff should
work on or near this equipment. Such
staff must be thoroughly acquainted with
all the warnings and maintenance
2
We have checked that the contents of the
technical publication agree with the hardware
and software described. However, it is not
possible to rule out deviations completely, so we
are unable to guarantee complete agreement.
However, the details in the technical publication
are checked regularly. Any corrections which
prove necessary are contained in subsequent
editions. We are grateful for suggestions for
improvement.
We reserve the right to make technical
modifications.
Permission is not given for the circulation or
reproduction of this document, its use or the
passing on of its contents unless granted
expressly. Contravention renders the perpetrator
liable for compensation for damages. All rights
reserved, in particular in the case of patent grant
or registration of a utility or design.
© Copyright Schneider Automation 1999
All Rights Reserved
Note
We would point out that the content of these
operating instructions is not part of, nor is it
intended to amend an earlier or existing
agreement, permit or legal relation-ship. All
obligations on Schneider Automation arise
from the respective purchasing agreement
which also contains the full warranty conditions which have sole applicability. These contractual
warranty conditions are neither extended nor
restricted by comments in these operating
instructions.
We would furthermore point out that for reasons
of simplicity, these operating instructions cannot
describe every conceivable problem associated
with the use of this equipment. Should you
require further information or should particular
problems occur which are not treated in
sufficient detail in the operating instructions, you
can request the necessary information from your
Schneider Electric regional sales office.
General
Electricity is used to operate this equipment.
Comply in every detail with the safety
requirements specified in the operating
instructions regarding the voltages to apply!
measures contained in these operating
instructions.
The proper and safe operation of this
equipment assumes proper transport,
appropriate storage and assembly and
careful operation and maintenance.
Staff qualification requirements
Qualified staff within the meaning of these
operating instructions or the warning notes are
persons familiar with setting up, assembling,
starting up and operating this product and who
have appropriate qualifications to cover their activities, such as:
- training or instruction/entitlement to switch
circuits and equipment/systems on and off,
ground them and identify them in accordance
with current safety standards;
- training or instruction in accordance with
current safety standards in looking after and
using appropriate safety equipment;
- first aid training.
Warning
Ethernet Transceiver 100 Mbps TX/FX
units are designed for operation with safe
extra-low voltage. Accordingly, only safe
extra-low voltages (SELV) conforming to
IEC950/EN60950/VDE0805 may be
connected to the supply voltage
connections.
Safety guidelines