Sony SRS-BTM30 - Manual (Page 12)

12
US
When pairing with a BLUETOOTH stereo audio source device that cannot display a list of
detected devices or that has no display
You may pair the device by setting both this unit and the BLUETOOTH stereo audio source device to
pairing mode. For details, refer to the operating instructions supplied with the device.
If pairing is not complete
Start over from step 1.
Tip
To pair with other BLUETOOTH devices, repeat steps 1 to 5 for each device.
Note
Passcode of this unit is fixed to “0000.” This unit cannot be paired with a BLUETOOTH stereo audio
source device whose Passcode is not “0000.”
Listening to the sound
Check the following before operating the unit.
– The BLUETOOTH stereo audio source device’s BLUETOOTH function is on.
– Pairing of this unit and the BLUETOOTH stereo audio source device is complete.
– If you have been listening to the sound from the source device connected to the INPUT jack, stop
playing on the device or turn off the device.
1
Press the 1 button to turn on this unit.
2
Start the BLUETOOTH connection from the BLUETOOTH stereo audio
source device.
3
Start playing on the BLUETOOTH stereo audio source device.
Note
If the source device has a bass boost function or equalizer function, set them to off. If these
functions are on, sound may be distorted.
4
Adjust the volume.
Set the volume of the BLUETOOTH stereo audio source device to moderate level, and
press the VOLUME +/– buttons on this unit.
Note
A beep sounds when the volume is set to minimum or maximum.
Notes
• In the following cases, you need to make the BLUETOOTH connection again.
– The power of this unit does not turn on.
– The power of the BLUETOOTH stereo audio source device does not turn on, or the BLUETOOTH
function is off.
– The BLUETOOTH function of this unit or the BLUETOOTH stereo audio source device is in sleep
mode.
– The BLUETOOTH connection is not made.
• If both the BLUETOOTH connected device and the one connected to the INPUT jack are played at the same
time, both sounds can be heard.