Samsung SCX-4828FN - Manual (Page 76)

76 _ Troubleshooting
Common PostScript problems (SCX-4x28 Series
only)
The following situations are PS language specific and may occur when
several printer languages are being used.
Common Windows problems
Blank areas appear
at the bottom of each
page or on other
pages, with a small
strip of text at the
top. You may have chosen the wrong paper settings
in the user option setting. For details about
paper settings, see page 31.
To receive a printed or screen-displayed message when PostScript
errors occur, open the Print Options window and click the desired
selection next to the PostScript errors section
PROBLEM
POSSIBLE
CAUSE
SOLUTION
PostScript file
cannot be
printed. The PostScript
driver may not be
installed correctly.
• Install the PostScript driver,
referring to Software
section
.
• Print a configuration page
and verify that the PS
version is available for
printing.
• If the problem persists,
contact a service
representative.
“Limit Check
Error” message
appears. The print job was
too complex.
You might need to reduce the
complexity of the page or
install more memory.
A PostScript
error page prints. The print job may
not be PostScript.
Make sure that the print job is a
PostScript job. Check to see
whether the software
application expected a setup or
PostScript header file to be
sent to the machine.
The optional tray
is not selected in
the driver. The printer driver
has not been
configured to
recognize the
optional tray.
Open the PostScript driver
properties, select the Device
Settings
tab, and set the Tray
option of the Installable
Options
section to Installed.
CONDITION SUGGESTED SOLUTIONS
CONDITION SUGGESTED SOLUTIONS
“File in Use”
message appears
during installation. Exit all software applications. Remove all
software from the StartUp Group, then restart
Windows. Reinstall the printer driver.
“General Protection
Fault”, “Exception
OE”, “Spool32”, or
“Illegal Operation”
messages appear. Close all other applications, reboot Windows
and try printing again.
“Fail To Print”, “A
printer timeout error
occurred.” messages
appear. These messages may appear during printing.
Just keep waiting until the machine finishes
printing. If the message appears in ready mode
or after printing has been completed, check the
connection and/or whether an error has
occurred.
Refer to the Microsoft Windows documentation that came with your
computer for further information on Windows error messages.