Sagem 700 - Manual (Page 20)

20
I
NSTALLATION
2.1.3. Configuration as a Wired Client
If there is no 802.11b/g wireless network in your home, and only a wired 802.3 network is
available, the IP Radio device can connect to the wired network via an Ethernet cable.
In this case, before powering the device, you need to plug the Ethernet cable into the RJ45
connector. The device will automatically switch to the wired client mode when it detects a link
status via the Ethernet connection.
Manually set to the Wireless Client Mode (continued)
8 "OK" button Confirm the
settings above.
9 Apply new settings.
10 The device is now
in wireless client
mode.
11 The device is
already connected
to your network.