Schneider Electric 107FB4/10 - Manual (Page 10)

6
Connect your computer
L
R
AUDIO
OUT
Amplifier
To connect to a hi-fi system, use an audio connection
cable and connect the
L and R AUDIO outputs on the
TV set on the AUDIO IN L and R input on your hi-fi
amplifier.
AUDIO
1
R
L
2
VGA
IN
& Connect one end of a VGA cable 1 to the video card
of the computer and the other end to the
VGA IN
connector at the bottom of the TV.
Fix the connectors firmly with the screws on the plug.
é In case of a Multimedia computer, connect the audio
cable 2 to the audio outputs of your Multimedia
computer and to the
AUDIO R (right) and L (left)
inputs.
The VGA connector allows the following TV and
monitor display modes:
VGA 640 x 480 60 Hz
SVGA 800 x 600 60 Hz
XGA 1024 x 768 60 Hz
WXGA 1280 x 768 60 Hz
Note:
Use the WXGA1280x768@60Hz video mode to obtain the best
image quality for your PDP monitor.
Press the v key on the remote control repeatedly to select EXT1 , EXT2 (S-VHS signals from the EXT2
connector) or AV according to where you connected your equipment.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
2328.1 gb 07-03-2005 09:26 Pagina 6